This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
The Shand & Jurs Detonation Flame Arresters provide protection against flame propagation through piping runs and vapor recovery systems, while allowing maximum flow efficiencies. This design quenches a flame front approaching from either direction, even if it has transitioned to a detonation. The Arresters contain a detonation while retaining the integrity of both the arresting element and the housing. This is ensured by the design of the passages in the tube bank and the detonation resistant construction.
Standard construction of the housing is available in Carbon Steel or 316 Stainless Steel. The tube bank is Stainless Steel throughout. Special construction materials to withstand the corrosive actions of some vapors and atmospheric conditions are available upon request.
Because of the severe service conditions that the Detonation Flame Arrester encounters, all construction welding is performed in accordance with ASME Boiler and Pressure Vessel Code Section Vlll and IX. Class 150lb. hydrostatically tested at 425 psig. Class 300lb. hydrostatically tested at 750 psig.
These models are available in a range of sizes from 2" through 24". Additional sizes available upon request. Standard connections are ANSI 150lb. or 300lb. Class raised face flanges
FEATURES
• Withstands instantaneous pressure at the flame front in excess of 500 psig • Tube bank design ensures consistent functioning • Carbon steel or 316SS housing construction, 316SS tube bank • Optional fittings for pressure taps or temperature probes • Designed & tested in accordance with appendix A, 33 U.S. Code of Federal Regulations part 154 • Standard drain plug