This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
1.Velocity is as low as 1,000 ft/min is possible depending on amount of residual superheat and temperature differential between vapor and coolant. 2.25:1 turndown is subject to a check on the amount of atomizing vapor being used. 3.Pressure breakdown orifices or PRV may be required in order to limit the pressure drop to less than critical. 4.Velocity shown is seat velocity. Inlet and outlet velocities will be much lower.
5.Control accuracy is a function of the complete system which includes temperature controller and coolant valve. 6.Application involving pressure reduction will include a pressure reducing valve (PRV) and pressure controller. 7.6”-24” Header for 3/2 & 3/3; 12”-24” Header for 3/5 and 12”-20” Header for 4/5 Model.
GN-03 PS No. 23 & 24 70% of “DTS” MA-I I 30-50 ft. 3 pipe
diameters (not less than 3 ft.)
70% of “DTS”
MA-I I I 16-30 ft. 5 pipe
diameters not less than 4 ft.)
70% of “DTS”
16-30 ft.
5 pipe diam- eters
not less than 4 ft.)
70% of “DTS” 20-33 ft. 6 pipe
diameters (not less than 1 ft.)
50% of “DTS”
25-40 ft.
3 pipe diam- eters
(not less than 4 ft.)
80% of “DTS” 16-30 ft.
5 pipe diam- eters
not less than 4 ft.)
70% of “DTS”
SAMN VAD SA-35 MNSD-V VO-76 12-20 ft. VO-I I 12-20 ft. 12-18 ft.
Long radius elbows may be installed at inlet and outlet
Long radius elbows may be installed at inlet and outlet