This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
Solid State/Pulse Input Positioner - Continued Table 1
XXX
Table 1 AV4
Table 2 4
Table 3 1
2
Table 4 0 1
3
Table 5 0
Table 6 0 1 2 3 4 5
Table 7 0
N P
Positioner Type
Solid State/Pulse Input Positioner AV4 Input Signal 24 Vdc pulse
Stroke or Rotary Motion
0.5 inch (12.7 mm) to 2.0 inch (50.8 mm) or 45 Degrees Rotation
1.0 inch (25.4 mm) to 4.0 inch (101.6 mm) or 90 Degrees Rotation
Manifold / Gage Block No Manifold
Manifold with Equalizing Valve, Filters & Gage Ports (See Note A)
Gage Block (gage ports only) Position Transmitter
4-20 mA (Standard) (See Note B) Drive Shaft
Standard with Drive Arm (for Linear Actuators and UP3/4/5/6) 0.500 inch Square End (most common for 90° Actuators) 0.342 inch Square End (older DeZurik/K&M Actuators) 0.250 inch Flats (UP1/UP2 after 8/95)
0.375 inch Square End (for DeZurik PowerRac Actuators) 0.156 inch (4 mm) Flats (for Namur Rotary Mounting) Options
No Options
NEMA 4X Enclosure Rating (must be installed per dwg 258567) Performance Series (High Pneumatic Gain)
Note A: Required for Double acting Actuators with Manual override such as UP or AC actuators Note B: The 4 to 20 ma output position transmitter is a standard feature of Type AV44 positioner. The positioner transmitter options are only