Nautical Research Journal 167


Figure 16 (inset) and Figure 17.


In addition to the ladders, railings are an important enhancement to any 1:350-scale model. Curves and circles are a special challenge because of the “spring- back” of the material. I have found the Multi-Tool from Mission Tools to be invaluable for such pur- poses. (Figure 18) It took a lot of eff ort but, eventu- ally, I ended up with a nice circle and attached it to its airbrushed base. T e fi nal step was to touch up


the paint with an Artetje 100/0 Micro Paint Brush. (Figure 19)


Straight railings are quite a bit easier than curved ones. I use dividers to determine the locations of the stanchions and cut the lengths of each segment re- quired. Tamiya bending tools allow me to make all corner bends without fi xtures. (Figures 20 to 22)


Figure 18.


Figure 19.


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74  |  Page 75  |  Page 76  |  Page 77  |  Page 78  |  Page 79  |  Page 80  |  Page 81  |  Page 82  |  Page 83  |  Page 84  |  Page 85  |  Page 86  |  Page 87  |  Page 88  |  Page 89  |  Page 90  |  Page 91  |  Page 92  |  Page 93  |  Page 94  |  Page 95  |  Page 96  |  Page 97  |  Page 98  |  Page 99  |  Page 100