(6)


With the bracket secured to the vehicle the heater can be snapped onto the bracket. Note the top clip — listen for the “click” to be sure it has been securely mounted.


(8)


With the hoses and wiring routed, the reservoir was reinstalled. Here, the location of the heater can be seen.


(7)


Using the supplied rubber hose, the fluid input hose was routed from the reservoir and output to the nozzles. Be sure the hoses are not pinched or kinked and are not routed near moving engine parts or other hazards.


(10) (9)


The ground wire was connected to one of the vehicle’s factory grounding locations. This is found behind the battery tray and was made before the tray was reinstalled.


The Clear2Drive unit comes with pre-terminated ends for both the power and ground as well as pre loomed wire and a Maxi in-line fuse holder. The quality of the unit really shows, and it looks to provide years of reli- able service for the customer.


www.me-mag.com 63


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68