news digest ♦ Solar
phosphide nanowires much smoother, and with fewer imperfections
Energy losses in nanowire solar cells can be significantly reduced by ‘cleaning’ the surface of the cells with a special etching method.
This has been shown by researchers at Eindhoven University of Technology (TU/e), Delft University of Technology and Philips in a paper published in the journal Nano Letters.
The solar cell has an efficiency of 11.1 percent, which the research say put it just below the current world record, but it was reached with much less use of material. This is the latest step forward in the rapid development of this type of solar cell in recent years.
with fewer imperfections. They do this using an etching method that they have developed themselves - called ‘piranha etching’ - in which the surface is ‘cleaned’ by a chemical reaction.
Efficiency boost
Their solar cell reaches an efficiency of 11.1 percent - slightly less than the current world record of 13.8 percent which was achieved earlier this year by a group of Swedish, German and Chinese researchers using nanowires made of the same material.
However the nanowires of the Dutch researchers are only 40 percent as thick. Since the efficiency normally falls as the wires become thinner, the expected efficiency should be only around 4.5 percent. Which means the ‘cleaning job’ in fact gives a significant boost in efficiency.
The researchers see opportunities to raise efficiency further in the near future with little extra use of resources. “By varying the thickness of the nanowires and improving the way the crystals inside them are stacked, we think we should soon be able to approach an efficiency of 20 percent”, says Bakkers. In the longer term, it should in theory even be possible to reach efficiencies of 65 percent by stacking multiple subcells.
This work is described in further detail in the paper, «Efficiency Enhancement of InP Nanowire Solar Cells by Surface Cleaning,» by Yingchao Cui et al in Nano Letters (2013).
http://pubs.acs.org/doi/abs/10.1021/ nl4016182
A nanowire array in the solar cell. (Photo: Eindhoven University of Technology)
The nanowire solar cell is a relatively new type of cell in which a bundle of semiconducting wires, each with a thickness of around 100nm, collect light and convert it into electricity. Big advances have been made in the development of this type of solar cell in recent years, and the efficiencies achieved are increasing rapidly by around 5 percent per year - much stronger growth than that of competing solar cell technologies.
Relatively large surface area
A big advantage of thin nanowires is the greatly reduced need for costly semiconductor material, which means they can be produced at low cost. However a disadvantage is their large surface area relative to the volume - and the surface is exactly where imperfections in the material lead to high energy losses.
In the publication in Nano Letters the researchers, led by Erik Bakkers and Jos Haverkort, describe a method to make the surface of InP nanowires much smoother,
104
www.compoundsemiconductor.net October 2013
NRL achieves highest open- circuit voltage for QD solar cells
It is possible to improve the passivation of PbS QDs by using an optimised lithium fluoride thickness
U.S. Naval Research Laboratory (NRL) research scientists and engineers in the Electronics Science and Technology Division have demonstrated what they say is the highest recorded open-circuit voltages for quantum dot solar cells to date.
Using colloidal lead sulphide (PbS) nanocrystal quantum dot (QD) substances, researchers achieved an open- circuit voltage (VOC) of 692 millivolts (mV) using the QD bandgap of a 1.4 electron volt (eV) in QD solar cell under one-sun illumination.
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116 |
Page 117 |
Page 118 |
Page 119 |
Page 120 |
Page 121 |
Page 122 |
Page 123 |
Page 124 |
Page 125 |
Page 126 |
Page 127 |
Page 128 |
Page 129 |
Page 130 |
Page 131 |
Page 132 |
Page 133 |
Page 134 |
Page 135 |
Page 136 |
Page 137 |
Page 138 |
Page 139 |
Page 140 |
Page 141 |
Page 142