The cable sheathing may optionally be interrupted at the contact point or removed completely inside the enclosure. The cable shield in the enclosure is retained. The supplied lock nut cuts automatically into the paint when screwed down, thus creating a conductive connection.
1) Minimum shield diameter = cable diameter minus cable sheathing
EMC shield bus
Made of corrosion-proof steel strip, 75 mm2 cross section, for cable shield contact.
Supply includes: – Assembly parts
Rail length mm
375 550
Connections Packs of Model No. 2413.375
10 16
1 pc(s). 1 pc(s).
2413.550
EMC earth clamps
The clamps may be used directly on the device or operating equipment on the mounting plate for cable shield contact.
Material: – Sheet steel
Surface finish: – Zinc-plated
Size mm
4 6 8
12 16 20
1) 2 assembly brackets
Packs of 50 pc(s).
50 pc(s). 50 pc(s). 50 pc(s). 50 pc(s). 25 pc(s).
Model No. 2367.040
2367.060 2367.080 2367.120 2367.160 2367.2001)
Contact cutter
The contact cutter enables EMC-compatible prepa- ration of the contact point e.g. for earthing braids. Plastic-bound abrasive with guide pin for round sys- tem punchings. With location point for drill, grinder etc.
For
Frame section Earthing bolts1)
1) Not necessary with TS
Model No. 2414.000 2414.500
Contact paint
Contact paint prevents the corrosion of conductive, unprotected contact points.
Contents: – 12 ml
Packs of 1 pc(s).
Model No. 2415.000
760
Further technical information available on the Internet.
