for TS/TS For baying two populated enclosures on the vertical enclosure section. Simply locate into the vertical TS punchings, secure and connect both brackets using the hex screws (supplied loose). Using the fastening bolts, the enclosure is pulled into a defined end position, with a height or side offset of up to ± 2 mm.
Material: – Sheet steel
Surface finish: – Zinc-plated
Supply includes: – Assembly parts
Packs of 6 pc(s).
Model No. 8800.670
Baying cover, vertical
To balance out the gap between the side panels when baying back-to-back. For enclosure height 2200 mm, or may be cut to length individually for lower heights.
Material: – Cover section: Plastic
Colour: – RAL 7035
Supply includes: – Assembly parts
Packs of 2 pc(s).
Also required: – Baying clamp, exterior, 8800.490, see page 654
Model No. 8800.870
Baying clamp, horizontal
for back-to-back mounting Two-piece, for in situ assembly of enclosures with mounting plate in the rearmost installation position.
Material: – Sheet steel
Surface finish: – Zinc-plated
Supply includes: – Assembly parts
Packs of 4 pc(s).
Model No. 8800.170
Rittal System Catalogue 35/System accessories
Further technical information available on the Internet.
