for fan-and-filter units / outlet filters If existing mounting cut-outs for fan-and-filter units/ outlet filters need to be closed to achieve a higher protection category, the filter mat of the fan-and-fil- ter unit/outlet filter can simply be replaced with a blanking cover; welding or other mechanical modifi- cation of the enclosure is not necessary.
Material: – Plastic
Colour: – Anthracite
Protection category IP to IEC 60 529: –IP 54
To fit Model No. 3237.... 3238.... 3239....
3240..../3241.... 3243..../3244..../3245....
Packs of Model No. 3237.020 3238.020 3239.020 3240.020 3243.020
2 pc(s). 2 pc(s). 2 pc(s). 2 pc(s). 2 pc(s).
Front outlet grille 2 U
for tangential fans This front outlet grille is required if a 482.6 mm (19") cross-flow blower (SK 3144.000/SK 3145.000) is used in the lower section of the electronic enclo- sure and the hot air is to be expelled to the outside from the upper section of the enclosure. The design of the grille matches that of the intake grille in the cross-flow blower. These grilles can also be used as simple inflow and outflow grilles with natural convec- tion.
Packs of 1 pc(s).
Accessories: – Filter mats, see page 454
Model No. 3176.000
Enclosure internal fan
for TS To prevent hot-spots and support the air routing of active enclosure climate control components. Adjustable in two axes. Attached to the TS 8 frame section. Several fans may be cascaded using the quick-release clamping strip.
Supply includes: – Complete unit with radial fan ready for connection – Snap-on pivot device – Assembly parts
Air throughput
(unimpeded air flow) m³/h
160 160 160
Rated operating voltage V, ~, Hz
230, 1~, 50/60 115, 1~, 50/60 24 (DC)
Power consump- tion W
19 / 18 19 / 18 3.5
Rated current A Packs of
0.12 / 0.11 0.24 / 0.23 0.15
1 pc(s). 1 pc(s). 1 pc(s).
Model No.
3108.100 3108.115 3108.024
Rittal System Catalogue 35/Climate control
Further technical information available on the Internet.
