For ◾ TS base/plinth ◾ Flex-Block base/plinth system ◾ Base/plinth, complete For fastening the base/plinth to the floor without moving the enclosure or bayed enclosure suite. For assembly screws up to 12 mm Ø.
Material: – Sheet steel
Surface finish: – Zinc-plated
Packs of 10 pc(s).
Model No. 2817.000
Fastening bolts
For ◾ TS base/plinth ◾ Base/plinth, complete ◾ Base/plinth, stationary For mounting on base/plinth trim panels, side. The lockable fastening bolt allows the installation of cable clamp rails. Tighten with hex spanner, width across flats 19 mm.
Material: – Hexagonal steel
Surface finish: – Zinc-plated
For base/plinth trim panel height mm
100 200
Accessories: – Cable clamp rail, see page 783
Packs of 10 pc(s).
10 pc(s).
Model No. 2819.000
2819.200
1) Only for height 200 mm
Levelling component
for TS base/plinth For retrospective levelling on uneven floors at the installation site up to a maximum of 15 mm. Installed through the corner piece of the base/plinth component. Adjusted using a hex spanner, width across flats 19 mm.
Benefits: ◾ A door offset caused by uneven flooring can be corrected
◾ Installed on the assembled enclosure, i.e. no need to plan levelling in advance
Load capacity: – Max. admissible static load: 2500 N per levelling component (check the load capacity of the floor)
Supply includes: – Assembly parts
For base/plinth height mm
100 200
Packs of 4 pc(s).
4 pc(s).
Model No. 2891.000
2892.000
622
Further technical information available on the Internet.
