for TS As a cable chamber for cable infeed from above or for power distribution with busbar systems across bayed enclosures. The TS cover plate supplied as standard is used to finish off at the top. The enclo- sure height is increased by 200 mm with the top module fitted. The top baying cover cannot be fitted. Installation accessories for top and bottom, see diagram and explanations below.
Material: – Sheet steel, 1.5 mm
Surface finish: – Spray-finished, textured paint
Colour: – RAL 7035
Protection category IP to IEC 60 529: – IP 55
NEMA protection category: – NEMA 12
600 800
1000 1200
For enclosures
Width (B) mm
Depth mm
600 600 600 600
Supply includes: – 1 frame module – 2 trim panels (front and rear) – 8 retainers with automatic potential equalisation
– 4 tapped rods with eyebolts Also required:
– Side panel for top-mounting module 8801.775, see page 692
Model No.
8801.735 8801.745 8801.755 8801.765
Accessories: Description TS punched rail 18 x 38 mm
PS punched rail 23 x 23 mm with angle bracket
PS punched rail 23 x 23 mm with PS support bracket
11 1 2 3 4 5
PS punched section without mounting flange 23 x 73 mm
with PS support bracket
PS punched section with mounting flange 23 x 73 mm
Support rail System support rails 10
C ail 30/15 with support bracket or spacer
Cable clamp rail TS punched rail 25 x 38 mm
TS punched section without mounting flange 45 x 88 mm
722 724
724 723 783
719 719
Page 720
721 721 723
1
6
7
8
9
Side panel
for top-mounting module To finish off the side of a top-mounting module or bayed suite.
Material: – Sheet steel, 1.5 mm
Surface finish: – Spray-finished, textured paint
Colour: – RAL 7035
Supply includes: – Assembly parts
Packs of 2 pc(s).
Model No. 8801.775
692
Further technical information available on the Internet.
