VIEWPOINT
PITCH PERFECT S
Stuart Nicholson, roof systems director at Marley
ince the relaxation in planning laws for single storey rear extensions back in 2014, demand for low pitch roofing products has increased significantly. This is because this type of project often calls for a lower pitched roof due to the position of first floor windows and to maximise floor space, yet homeowners tend to prefer the performance and aesthetic of a tiled roof, rather than a flat roof. Whereas in the past, there was a very restricted range of products for low pitch roofing projects, now customers no longer have to compromise on style, texture or colour. In fact, there is a growing selection of tiles specifically designed for low pitch roofs and recent innovations mean there are some great, easy-to-install clay and concrete options.
So, it may be useful for merchants to have some answers to commonly asked questions from customers about low pitches:
1. What counts as a low pitch roof?
The pitch of a roof is governed by a number of factors, such as the foundation footprint and building height limitations. Typically the average roof pitch for new build properties in the UK is circa 30-35 degrees, although this may vary for a number of design reasons. Traditional concrete interlocking tiles are designed to perform down to 22.5 degrees, anything lower than this, particularly less than 15 degrees, is considered as low pitch. If a roof pitch is below 10 degrees, you would either need a conventional flat roof solution or consider large format cement or metal
interlocking pantile has a low minimum pitch of 17.5 degrees.
corrugated sheets instead, which can typically fall into the flat roof category.
2. Can I get any concrete tiles that can be used below 15 degrees?
We have just launched a new, low pitch concrete interlocking tile, Mendip 12.5, which has been designed with low pitch projects in mind. It has the same double pan design as the original Mendip tile, but has special weatherproofing channels so that it can be used down to a very low pitch of 12.5 degrees. It is already available in two colours, Smooth Grey and Smooth Brown, and we are about to launch a new colour, Old English Dark Red. We also offer three other low pitch concrete roof tiles. Our large format Wessex and Mendip concrete interlocking tiles can be used down to a minimum 15 degrees pitch and our thin leading edge, slate effect Edgemere interlocking tile has a 17.5 degree minimum pitch.
3. What is the lowest minimum pitch for a clay roof? When it comes to clay plain tiles, we are the only manufacturer who offer two types of single camber tile which can be used on roof pitches as low as 30 degrees, whereas the majority of single and double camber clay plain tiles can only be used down to 35 degree pitches.
However, there are also clay interlocking tiles which allow customers to achieve the traditional clay look at a much lower pitch. For example, our Melodie clay interlocking pantiles can be used on pitches as low as 12.5 degrees. These tiles are particularly good for extension projects and are available in both Natural Red and Slate Grey colours to give customers more choice. For a more rustic appearance, our Lincoln
16
4. Are there any slate options for low pitch roofs? BS 5534 recommends that the minimum pitch for natural slate is 20 degrees, but there are some very good slate effect tiles that can replicate the slate look at a lower pitch for extension work. For example, our Edgemere range of thin-leading edge concrete slates give a slate look but are more cost effective and can be used down to pitches of 17.5 degrees. They come in a variety of colours and textures, including Riven, to help your customers match the slate aesthetic they need.
5. What happens if a customer wants to go below the recommended minimum pitch? You should warn against this as laying a product below its minimum pitch can prove to be a costly mistake. As well as the risk of invalidating warranties, the roof might not be signed off by building control upon completion, so it is always important to check with the manufacturer.
If roof tiles are installed below the recommended minimum pitch for aesthetic reasons, then the tiles should not be relied upon for performance. However, there may be proprietary sub-roof systems on the market to install beneath the tiles to provide this unction. In these instances, checking exposure is very important because the higher the rainfall, then the riskier this approach is. Our advice follows the BS 5534 recommendation that ‘a roof designed below the recommended roof pitch should have a functional weatherproof sub- roof system to remove any rainwater ingress safely to the eaves gutter’.
6. Are there additional products that should be purchased? All of our low pitch roof tiles are also available to purchase as part of a full roof system with battens, underlay, ventilation and fixings, backed up by a free 15-year guarantee. Extensions still need to be fixed in line with BS 5534 and purchasing a full roof system will help customers to make sure their project is fully weather tight and compliant. BMJ
www.buildersmerchantsjournal.net April 2020
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88
