search.noResults

search.searching

note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
IBERITAL


20ºC’ or ‘3ºF / Up to 36ºF’). (IT IS RECOMMENDED THAT THOSE VALUES ESTABLISHED BY THE MANUFACTURER BE MAINTAINED.)


Press the UP/DOWN buttons to select the desired temperature, and confi rm by pressing OK. Once this procedure is completed, press the MENU button to move on to the following option:


Water  lter xxxxxxx


The display will show the ‘WATER FILTER’ option, to select the number of litres of water consumed before the WATER FILTER CHANGE/REPLACEMENT ALARM activates. Press the UP/DOWN buttons to select the quantity of water in litres.


ATTENTION: If the water quantity is left at zero ‘0’ litres, the option will be DISABLED.


Lastly, press the MENU button to exit the TECHNICAL MENU. Off hh.mm


2.10.- DISPLAY ALARM SIGNALS A. MAXIMUM FILLING TIME FOR BOILER WATER


When a time set by the manufacturer is exceeded, the display will show:


Time-out alarm Boiler  llingUp


At the same time, the button LEDs begin to fl ash. To cancel the alarm, the main switch must be set to 0 and then to 1. B. MAXIMUM BOILER TEMPERATURE


The display will show the boiler temperature alarm when it exceeds 140ºC for more than 5 seconds. Alarm


Boiler temp. The alarm will disappear when the boiler temperature returns to its normal values.


C. INTERRUPTED TEMPERATURE SENSOR - When the sensor detects a temperature of 0ºC for 5 seconds, the LEDs on the button pads will fl ash and the display will show:


T.ProbeUnconnect The alarm will disappear when the boiler temperature is once again at an acceptable value.


- In the case of the control unit being replaced, a machine with a display and pressure switch will display:


T.ProbeUnconnect


This situation is due to an incorrect selection on the heating menu (reprogram the control unit). (SEE PROGRAMMING IN SECTION 2.9.5, HEATING MENU OPTION.)


INSTALLATION AND OPERATION MANUAL 


ENGLISH


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62