COLD ROOMS
Making the change with Danfoss
W
hen a busy hospital needed to relocate its cold room condensing units, consultant Neil Garnett knew it was time to upgrade to F-gas compliant refrigerants. He chose Optyma Plus units from Danfoss, running with R134a and, crucially, R452A.
When a hospital in the East of England decided to create a new service building, it meant relocating seven roof-mounted condensing units cooling the hospital’s mortuary.
The hospital turned to its framework consultant, Johns Slater and Haward (JSH) and as senior mechanical engineer Mr Garnett pointed out, it was no easy task.
He explained: “The hospital can’t just stop working and you can’t predict a quiet period. I needed to come up with a design that would let the contractors work fast and at relatively short notice when the opportunity arose.”
A recent survey revealed the condensing units were due for replacement, presenting Mr Garnett with a further challenge: convincing a cost-conscious hospital to move away from ozone-depleting R22 to a lower-GWP (Global Warming Potential) alternative, complying with F-gas regulation.
Mr Garnett said: “I wanted to provide a solution which fully complied with F-gas regulation and the 2020 phase down of higher GWP refrigerants, whilst at the same time ensuring the new installation met all the operational requirements.
“Capital expenditure and life cycle costs are a priority at any hospital, but they could see it was in their interest to have a unit they could rely on in the future without having to replace it again. We worked with the maintenance contractor on the specifi cation, and everyone agreed we’re getting what’s best for the hospital.”
Knowing that Danfoss off ers a range of lower- GWP cooling solutions, Mr Garnett discussed his options with the company’s commercial consultant, Mark Fiddy.
Mr Garnett recalled: “I knew Danfoss and the Optyma range very well. I met with Mark and when I heard about his experience, I felt reassured. I didn’t realise Danfoss had R452A Optyma units and I liked the sound of it.”
With Mr Fiddy’s support, Mr Garnett specifi ed seven new generation Optyma Plus condensing units, fi ve MBP units running R134a plus two LBP versions using R452A, allowing the mortuary staff the ability to rapidly drop the temperature in two smaller cold rooms to -18 °C. Both R134a and R452A have a GWP level below 2500 and are therefore fully compliant with the F-gas regulation.
Mr Garnett added: “With its lower-GWP refrigerants strategy, Danfoss was clearly the way forward. The backup support has been good, and the fact that Optyma is a packaged unit makes it so much easier for the contractors to work quickly.” Another fan of the Optyma Plus condensing units is Les Mitchell, branch manager at Pitkin & Ruddock, Bury St Edmunds branch, who installed the new system. He remarked: “We need to make sure the design is right. When we see Optyma outdoor units specifi ed, it’s always a relief.
“We use Optyma ranges wherever possible, anywhere from small cold rooms to large freezer rooms. Everything’s in there – fi lter drier and sight glass – and it’s already housed and easy to install. It’s plug and play, and that reduces downtime. The units are very quiet so you can use them without disruption or complaints.”
Mr Mitchell was also very impressed by the timing of the decision to switch to lower-GWP – echoing
Mr Garnett’s view that it’s in his customers’ best interests.
He commented: “Given the short lifespan of R404A, the number of those units still being sold seems strange. We’ve been trying to phase out R404A for the last twelve months so it’s helpful that Danfoss are providing clear advice on a compliant replacement.”
Despite unseasonable weather interrupting installation, the easy-to-use nature of the Optyma units meant Mr Mitchell and his team could meet the challenging schedule.
He says: “The hospital is really pleased. We didn’t cause too much disruption, and were able to decide on a day-to-day basis whether we could go ahead. Even with those gaps, we were still able to complete the job on time.”
Eight months since the fi rst units were commissioned, there have been no reported issues, and the condensing units are performing well. Mr Garnett said: “Danfoss condensing units are really effi cient. However, it was the longevity of the product that appealed the most. You can’t put in something that’s only going to last for two or three years.”
Importantly, the choice of R452A, and the support from Mr Fiddy at Danfoss, meant switching to lower- GWP refrigerant was no more diffi cult than any other job.
Mr Mitchell stated: “R452A was a new refrigerant for us, but it was really easy. Its wide temperature scale made it a good like-for-like replacement for R404A. As far as possible, everything we install now will be either R452A or R449A.”
Mr Garnett agreed: “The Danfoss technology is ready and available now, making selection simple and straightforward.”
36 September 2017
www.acr-news.com
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84
