This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
ABS LAMP HOUSINGS These moulded ABS housings are designed to accept our 95mm diameter rear lamps and our rectangular Rear Fog and Reverse. SINGLE RECTANGULAR CARBON EFFECT (shown fitted with a red #FL2) 102mm diameter x 92mm x 58mm high. #HOUSCB £12 each (£14.40 inc vat)
SINGLE RECTANGULAR BLACK 102mm diameter x 92mm x 58mm high #HOUSBK £10 each (£12 inc vat)
SINGLE ROUND CARBON EFFECT 120mm diameter x 65mm high. (Shown fitted with a red #RL17) #HOU1 £12 each (£14.40 inc vat) SINGLE ROUND BLACK 120mm diameter x 65mm high #HOU1BK £10 each (£12 inc vat)
HOUSING FOR 125mm DIAMETER LAMPS Gloss Black moulded ABS housing for 125mm diameter rear lamps. Shown below with a #RL53. Moulded from 2mm thick ABS sheet it's mounting face diameter is 130mm. This means that a 125mm diameter lamp will sit nicely on the edge of the moulding radius. The height of the housing is 60mm so you can trim it to mount on an angled rear panel up to 20º off vertical. Housing is shown drilled for a #RL53 but will be supplied undrilled. MOUNTING TIPS: The trimmed edge can be fitted with our #TRMU2 rubber edging trim giving a good contact point with your panel. The housing can be mounted with long studs and / or spacing tubes through the panel. #HOU125 £8 each (£9.60 inc vat)
THESE HOUSINGS CAN BE CUT AT AN ANGLE TO MOUNT THE LAMPS VERTICALLY ON A SLOPING REAR PANEL. THE REAR EDGE HAS BEEN TRIMMED WITH OUR #TRMU2 AND THE WHOLE ASSEMBLY MOUNTED TO THE PANEL WITH M3 STAINLESS STUDDING AND NUTS. THE TWIN HOUSINGS BELOW CAN BE CUT SIMILARLY.
TWIN ROUND HOUSINGS 295mm x 115mm 70 high (shown below with a clear #RL20 and 60mm red reflector) CARBON EFFECT #HOU2 £22 each (£26.40 inc vat) TWIN ROUND BLACK #HOU2BK £22 each (£26.40 inc vat)
SEE HINTS & TIPS SECTION AT THE BACK FOR HOW TO CUT HOUSINGS AT AN ANGLE
Page 206 To order Tel: 01580 891309 or 01580 448007 or Fax: 01580 893733 ISSUE 31