This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
FUEL / WATER LEVEL SENDERS A range of four, fixed length senders. Stainless steel construction. No internal parts to go wrong. A metal-impregnated, lightweight float rises up and down the sender tube as the fluid level changes. A simple (white) adjustable clip allows you to set the bottom float position. 800mm heavy two core flex lead. Flange diameter 69mm. 20mm top projection. Five, 5.4mm holes on 54mm PCD. 3mm thick fuel-proof rubber gasket. 5 Screws supplied 10-24 UNC Resistance Empty 0 Ohms - Full 180 ohms. NOTE: If your instrument does not match the resistance of this sender you may get inaccurate readings.
THESE
SENDERS CANNOT BE CUT-DOWN
250mm
FUEL LEVEL SENDER ONLY Adjustable float sender that fits through a 43mm hole in your fuel tank. Sender flange diameter 75mm. Six 5.4mm fixing holes at 60mm PCD. Supplied with gasket. The 2mm diameter wire float arm comes in two halves which can be bent, cut and joined with the ring-crimps supplied. We recommend that, once you have set the float arm length, you solder the two wire halves together. Float arm travel 75 degrees. Float arm length adjustable between 150mm and 600mm. Minimum fuel tank depth 200mm. 1/4" spade terminal connections. 250 ohm resistance. Please check suitability with your instrument before purchasing. If the sender resistance does not match your gauge you may not get accurate readings.