Artificial Surfaces
required, but is ultimately non-porous, thus necessitating the installation of a drainage channel on either the inside or outside of the track to enable surface water to drain. Type two is the solid Polyurethane [PUR] system. This system is constructed using three layers of a poured polyurethane resin that has rubber granules cast into it to give it structure. The depth of the surface is generally 12-14mm. The top wearing layer of this surface has a similar appearance to the sandwich system. The PUR track is one of the most durable of all of the systems. Type three is a kit system, which consists of lengths of pre-fabricated track surface, usually one lane wide, which are glued down to the tarmac sub-base. Care must be taken with this system not to allow debris to collect in the many joints around the surface.
Surface Issues
Aside from the possibility of damage caused to the various surfaces by careless use of machinery, the majority of issues are caused by naturally occurring phenomenon. The most common issue for surfaces is the unwelcome growth of weeds, grass and moss to areas of the track that are neglected. During the life of the system, cracks may appear between the surface and the inner and outer kerbs, allowing dirt, seeds etc. to accumulate and thrive. Once established, the root systems will eventually weaken and undermine the edges, causing cracks to develop and the edges of the track to collapse. To avoid this, care must be taken to regularly clean and spray, with weedkiller, all edges around the track perimeter. In a similar fashion, grasses will try to grow in and around landing pits of the jump run-ups. Again, regular cleaning and removal of early growth will ensure that sand is not left to accumulate against kerb edges, and helps to avoid future issues. The track surface, being textured, will hold a little moisture and, in some locations, moss can be a particular problem if it is allowed to thrive. Regular treatment with a recognised moss inhibitor is recommended, at least quarterly if the location of your track makes it susceptible to moss growth. Areas of track that are shadowed by trees
require frequent cleaning to prevent the fallen leaves from both rotting on the surface, and either sealing porous tracks or creating slippery dangerous areas on the non-porous systems. If this material is left, it will blacken the track and the rotting leaves will encourage further growth of other plants. These areas may also hold pools of water which - when it freezes in the winter period
- open the surface of the track and cause it to crack over time. Another issue with debris that is particularly relevant to non- porous tracks is, when it accumulates in the drainage channels, they will become blocked and prevent the track from draining effectively, causing issues with standing water and encouraging unwanted growth of plant life. Taking all of this into consideration, it is
perhaps becoming clear that a little effort on a regular basis will eliminate many of the causes of long-term track degradation and, therefore, the need to spend much larger sums on rectification. As a general rule, a full, professional deep clean of the track should be considered every three to four years, depending on a track’s location and its frequency of use.
A number of smaller tasks should also be considered in order to fully prepare your track for winter, including:
1) Ensuring that only ‘clean’ sand is put back into the pits before covering them
2) Removing wooden take-off boards from runways and storing them inside
3) Wherever possible, removing landing mats and storing them in dry, secure storage areas - rabbits, rats and mice love them to overwinter in
4) Note any areas where water is pooling to remedy during the summer
5) Check drains are running clear, where possible clear/clean
6) Not leaving the last grass cuttings remaining on the track over winter to rot down
7) Ensuring that all covers are secured against potential winter winds and storms
8) Removing all equipment to storage areas - anything left on the track surface may well leave a shadow or rust mark when it is moved at the start of the new season (for example, hurdles and steeplechase barriers)
9) Where possible, draining the steeplechase water jump and insulating the feed pipes/valves with waterproof material
10)If the kerb is removable and is aluminium, then put it away (or risk losing it for scrap)
Although not linked to the winter maintenance of your track, be mindful of the surface you have and, where budgets allow, do not mix surface types with DIY repairs, as this will cause issues in the long term, particularly if you repair a non-
If you are having problems with rain, frost or snow, your artificial surface may need a Rejeneration® or Winter RevivalTM
Call us now for more information on our range of Winter Maintenance Services
What starts out as a cheap option could cost many more times to repair
porous system with a porous repair. This allows water to penetrate the surface and could lead to further delamination and lifting of the surrounding track if the water freezes. What starts out as a cheap option could cost many times more to rectify if this happens. Be aware of the heavy-wear areas of your track: start/finish lines, ends of throws and jump run-ups. If these areas are showing the classic signs of wear (i.e. the black base layer showing through), it is prudent to seek advice from a registered installer/repairer, as the base layer is much softer material and will degrade much quicker, causing potential hazards for athletes. Try to encourage athletics clubs to vary
the areas of training. Persuade them to avoid having ‘favourite’ lanes and starting positions. Spread the wear of your track wherever possible. In summary, although athletics tracks may appear to require very little maintenance, it is important to recognise that they do need attention all year round, including the winter months when usage is reduced. A closed track costs money, time and inconvenience and can be easily avoided with a worthwhile maintenance programme.
Unwelcome ingress of moss, grass and weeds
tel: 08702 400 700
email:
info@technicalsurfaces.co.uk www.technicalsurfaces.co.uk
DECEMBER/JANUARY 2013 PC 95
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116 |
Page 117 |
Page 118 |
Page 119 |
Page 120 |
Page 121 |
Page 122 |
Page 123 |
Page 124 |
Page 125 |
Page 126 |
Page 127 |
Page 128 |
Page 129 |
Page 130 |
Page 131 |
Page 132 |
Page 133 |
Page 134 |
Page 135 |
Page 136 |
Page 137 |
Page 138 |
Page 139 |
Page 140