This page contains a Flash digital edition of a book.
Assembly Instructions
for Versil-Flare
Tube Fittings
TY &
SPECIAL TRUCK HOSE
Cutting
To insure a leak-proof joint, the tubing should be cut square
(±1°). A tube cutter is preferred, but a hacksaw or abrasive
wheel can be used.
LOW & MEDIUM PRESSURE HOSE
Out of Square Cut Square Cut
Deburring
All cut tubes should be deburred. However, deburring is
even more important if the tubing was cut with a hacksaw
or abrasive wheel. Remove any burrs, both internally and
externally, with a deburring tool, emery paper or fine file.
Clean the tube before assembly. Clean all dirt and grit from
the I.D. and O.D. of the tube.
HIGH PRESSURE HOSE
HOSE FITTINGS
Assembly Instructions
for Versil-Flare
Tube Fitting
Tubing cut-off
5. Slide the ferrule and nut against body and tighten the
1. Tube should be cut to fit tight against the face of stan-
nut onto the body “Hand Tight.” Mark the nut in rela-
ADAPTERS & TUBE FITTINGS
dard SAE 37° flare body.
tion to the body for location.
Y INSTRUCTIONS
Initial assembly
1. Deburr the end internally and externally. Clean all dirt and
ACCESSORIES & ASSEMBL
grit from I.D. and O.D.
2. Slide the nut and then the ferrule into the tube. Make
sure the tapered end of ferrule points toward the nut. Y
6. Hold tube against body and tighten nut a total of 1
1
/
4
turns on –3 through –10 and 1
1
/
2
turns –12 through –32.
Reassembly
HOSE ASSEMBL
EQUIPMENT
1. Slide nut against the body and tighten to “Hand Tight.”
Mark the nut for location.
3. Lubricate all mating surfaces of nut, ferrule and body 2. Tighten nut a minimum of one “Hex” flat. The Versil-
with a heavy lubricant such as Aeroquip 222070 Lube. Flare flareless tube fitting is designed for a
4. Place end of tube against standard SAE 37° flare body.
maximum of 10 reassemblies.
APPENDICIES
www.EatonProducts.com
EATON Aeroquip Fluid Conveyance Products A-HOOV-MC001-E1 December 2007 315
Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50
Produced with Yudu - www.yudu.com