Technical
Close up of Silver- thread Moss
(Bryum argenteum)
invade when any of the following conditions are prevalent.
- Long periods of wet weather - Long periods of dry weather - Low soil fertility - Compacted soils - Low or high soil pH - Excessive shade - Poorly draining soils - High thatch contents - Poor air circulation - Closely mown/weak grass growth - High nitrogen levels
- Ineffective maintenance regimes, particularly mowing, fertilising, aeration, brushing, scarifying and pesticide/weed control operations
Grasses grow poorly in dense shade because of low light and increased disease activity; therefore, shady grass areas usually have more moss than grass areas in full sun. Thinning out trees by selective pruning, or removing them completely, may reduce moss encroachment. In some cases, it is easier to redesign the area and eliminate turf than it is to improve lighting.
When planting new areas in shady sites, be careful to select shade-tolerant grass species.
Wet soils, caused by poor drainage or excessive irrigation, provide a perfect environment for germination and growth of moss spores or plant fragments. Poor drainage sometimes can be improved by promoting water infiltration by core cultivation, slicing or thatch removal. These practices also improve turfgrass vigor and competitiveness.
Often, drainage can be improved by the installation of primary or secondary drainage systems to help remove surface water.
Algae
Algae can cause a glutinous slime (squidge) which is associated with fine turf situations. The form of algae commonly found in turf is a cyanobacteria, a phylum of bacteria that obtain energy through photosynthesis. It is more prolific during the spring when the ground conditions are moist and wet, and air temperatures and light levels begin to increase, thus stimulating the growth of these algae.
The symptoms show as dark green or black slimy growth that covers the plant and soil surface, resulting in a very slippery surface, which can be dangerous and affect surface playability. Conditions that increase the likelihood of an attack of algae are the same as moss, but are encouraged when surfaces remain waterlogged and smeared.
Surfaces affected
Early signs of moss on an artificial surface
Both natural and synthetic surfaces can be affected by moss and algae attack when the favoured conditions are prevalent. Playing characteristics are affected in that moss and algae can affect ball bounce/roll on fine turf situations. The slime that algae produce causes the biggest problem on sport surfaces, making them dangerous, particularly if algae has formed on sloping grass areas, such as golf fairways. Moss and algae also cause surface traction problems for players on artificial
surfaces, which may result in injuries. Control of Moss and Algae
The main reasons for moss and algae attack are poor maintenance and lack of effective cultural practices, coupled with environmental factors that stimulate moss and algae growth (wet, damp, or humid conditions).
Any cultural practices that encourages turf growth and development should be employed to control moss. Evaluate the site and make necessary plans to implement maintenance regimes to improve the soil environment, reducing excessive moisture and water from the turf surfaces.
Natural Turf surfaces: - Improve surface soil drainage - Monitor and maintain soil pH levels - Reduce soil compaction by aeration - Improve air circulation over surfaces
- Maintain soil fertility (carry out soil analysis)
- Maintain trees to prevent shading - Avoid excessive irrigation - Avoid close mowing - Control thatch
- Choose and grow recommended grass varieties for location and sport surface requirement
- Carry our regular maintenance regimes that reduce the environment for moss and algae, i.e. regular brushing, sweeping, aeration, scarification and fertiliser programmes
- Chemical control using approved pesticides
Artificial Turf surfaces - Keep surface clean - Regular brushing and sweeping
- Chemical control using approved chemicals at approved rates of application; it is important to seek manufacturer’s recommendations on what product to use on synthetic surfaces to prevent damage or discolouring
Conclusions
The best form of eradication is to ensure a healthy grass sward is maintained, which is usually achieved by good, regular maintenance regimes, particularly aeration to keep the soil in good condition. If, however, you are saddled with a turf situation that has a lot of moss present, there will be a requirement to kill the moss off with an approved chemical containing an active ingredient of Sulphate of Iron and, when it has died off, remove the dead matter by scarification/raking.
The best results are obtained by the optimum timing of operations, best suited to spring and autumn periods when grass growth is vigorous. However, soil analysis of turf facilities that have used these chemicals to control moss over long periods of time has found that chemical changes have occurred in the soil profile and have created other problems, iron pans have been formed by over-use of sulphate of iron, and pH levels can be influenced.
The best form of control is good cultural practices to reduce the environment that mosses and algae prefer.
DECEMBER/JANUARY 2014 PC 125
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116 |
Page 117 |
Page 118 |
Page 119 |
Page 120 |
Page 121 |
Page 122 |
Page 123 |
Page 124 |
Page 125 |
Page 126 |
Page 127 |
Page 128 |
Page 129 |
Page 130 |
Page 131 |
Page 132 |
Page 133 |
Page 134 |
Page 135 |
Page 136 |
Page 137 |
Page 138 |
Page 139 |
Page 140 |
Page 141 |
Page 142 |
Page 143 |
Page 144 |
Page 145 |
Page 146 |
Page 147 |
Page 148 |
Page 149 |
Page 150 |
Page 151 |
Page 152 |
Page 153 |
Page 154 |
Page 155 |
Page 156