Figure 35-6 GREEN SYSTEMS
| SOLAR SOLUTIONS | CONTINUED FROM PAGE 70
paint reads accurately at 141 F, which is the actual temperature of all the surfaces at that moment. The cleanest selective surface reads near zero, which indicates that it is doing its job as a low emissivity coating, holding on to the thermal radiation. The selective surfaces that are coated with dust and minerals read higher temperatures, showing that they need to be cleaned and restored to take advantage of that Low E benefit.
Summary Figure 35-6 shows one of the solar collector banks after
cleaning. Based on the observations, measurements and estimations, the results of this solar collector refurbishment effort can be summarized as follows for the overall surfaces of all the collectors combined. The low emissivity of the black plates was substantially
improved by the cleaning process. The following values are estimates based on comparison and interpolation of the IR temperature readings. Before cleaning – 0.51
72
After cleaning – 0.28 Original value – 0.17 This means that the solar heat loss by thermal radiation
has been reduced from a rate that was three times higher than the original to a rate that is only 1.6 times higher on average. Another way to say this is that the solar heat loss by radiation has been nearly cut in half. The high absorptivity of the black plates has been
improved as well, which is clearly visible when viewing the reassembled collectors that now have an obvious darker and cleaner appearance. The overall absorptivity values have been estimated as follows, based on the change in color of panels before and after cleaning. Before cleaning – 0.71 After cleaning – 0.90 Original value – 0.94
Final notes These articles are targeted toward
residential and small commercial buildings smaller than 10,000 square feet. The focus is on pressurized glycol/hydronic systems, since these systems can be applied in a wide variety of building geometries and orientations with few limitations. Brand names, organizations, suppliers and manufacturers are mentioned only to provide examples for illustration and discussion and do not constitute any recommendation or endorsement. l
Bristol Stickney has been designing,
manufacturing, repairing and installing solar hydronic heating systems for more than 30 years. He holds a Bachelor of Science in Mechanical Engineering and is a licensed mechanical contractor in New Mexico. He is the chief technical officer for SolarLogic LLC in Santa Fe, N.M., where he is involved in development of solar heating control systems and design tools for solar heating professionals. Visit www
.solarlogicllc.com for more information. I
n this series of articles, I have been making the case that the key
e Circle 45 on reader reply card
ingredients for solar/hydronic design and installation can be divided into six categories, listed below, roughly in order of their importance. 1. RELIABILITY 2. EFFECTIVENESS 3. COMPATIBILITY 4. ELEGANCE 5. SERVICEABILITY 6. EFFICIENCY The success of any solar hydronic home heating installation depends on the often-conflicting balance between any of these six principles. Finding the balance between them defines the art of solar heating design.;
phc june 2011
www.phcnews.com
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88