search.noResults

search.searching

saml.title
dataCollection.invalidEmail
note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
Installation For adhesive please apply one 310ml cartridge of wall panel adhesive per panel, in a dot and dab pattern. 1


We recommend that you begin with an internal corner and work outwards.


2


Apply a continuous bead of sealant to the reverse of the internal trim and fix in position. Use a spirit level to ensure it is plumb.


3


Apply a continuous bead of sealant into an end cap trim. Fix the trim to the edge of the panel. There should be enough sealant that it spreads outside the trim. Wipe off excess sealant. This same procedure should be followed when continuous trims are used to connect boards.


4


Apply a continuous bead of sealant into one recess of the internal trim. There should be enough sealant that it spreads outside the trim. Wipe off excess sealant.


5


Apply sealant to the wall in a series of waves from top to bottom of the area where the panel will be affixed.


3mm 3mm


SHOWER TRAY/ BATH


6


Place 3mm high spacers along the back edge of the shower tray to create a 3mm clear gap at the panel base to be filled with sealant.


7


Position the panel above the 3mm spacers and slide into the internal trim recess. The sealant should envelope the panel. Wipe away excess sealant. Repeat steps 3 to 7 for the second panel.


8


Apply sealant to the bottom joint of the panels and seal all end cap edges.


9


Cut-outs for shower heads and the like require an expansion gap of at least 3 mm. After fitting the boards these gaps must be filled with sealant.


10


Leave for 24 hours before use.


For full installation instructions please refer to our website. Care & Maintenance


Wipe clean with a non-abrasive damp cloth and a mild spray detergent. Abrasive cleaners and bleaches must not be used on Atlantis panelling.


Sealant needs to be replaced at regular intervals. Failure to do this may cause water ingress and subsequent panel damage.


14 / 15


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64