UPCYCLED FIMO HEART NECKLACE | BEGINNER


6: MARK THE DESIGN Mark out the inner design shape of your choice, either


with a scribe or by using a template.


Centre punch in the centre of this shape and use your drill bit to drill a hole through the piece.


Feed your saw blade through this drilled hole and then pierce out your inner design from the inside out.


6


7: FILE & BUFF Once you have finished saw piercing out your shape,


file and buff your Silver piece where necessary.


Then, centre punch the top of your piece and drill a hole suitable for your jump ring to fit through.


Using rouge and a cotton polishing mop, polish your piece to a high sparkling shine.


7


8: ASSEMBLE Now that you have your two pendant pieces, open your


jump ring sideways using pliers. Place both your Fimo and Silver piece on to the jump ring and then close the jump ring back up so it is flush and tight.


Place this onto your desired chain and you’re finished. 8


8


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40