TEXTURED STACKING RINGS | BEGINNER


6: FILE & SOLDER Place the remaining 2.4mm ring in a ring clamp with


the solder joint facing outwards. File a small flat space where the disc will sit on top. Gently melt some of the hard solder onto the face of the ring.


6


8


9: STAMP Place the ring back onto the mandrel and use the


ImpressArt design stamp to make impressions of stars on the disc. If required, polish over this disc again before applying the enamel marker pen to highlight the impressions. Wipe off the excess marker pen to reveal your design and you’re finished.


7: SOLDER THE DISC Place the 9ct yellow Gold disc rounded edge down


onto a soldering block. Position the ring on top so that the soldered flat edge meets in the centre of the circle. Solder together, focusing the heat on the ring first to protect the Gold.


7 9


8: FILE & BUFF File away any excess solder and buff using emery


papers. Polish the 9ct yellow Gold disc to a mirror finish, and use the scotchbrite pendant wheel to matte the ring shank (this can be done by hand if you do not own a pendant motor).


11


TEXTURED STACKING RINGS


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40