FROSTED SNOWDROP EARRINGS | BEGINNER


1: PREPARE THE DISC Start by preparing your Silver discs to remove any


surface scratches. Place your abrasive paper flat on your bench and rub the blank over it to create a smooth surface.


3: DRILL Place your discs on a wooden surface and use your


1mm drill bit to drill a hole through each of your indented points.


1


3


2: MARK Using a fine tip marker pen, mark a dot on the top


and bottom of the two small discs and the two medium discs. Mark one dot on the bottom of the two large discs. Use a steel pointed punch and a rawhide mallet to indent a mark onto each of the marked dots.


4: ANNEAL & PICKLE Arrange your pieces onto a wire mesh and anneal


the metal using your torch. Once the discs are fully annealed, place into your pickle using brass tweezers and leave for five minutes.


4 2


31


FROSTED SNOWDROP EARRINGS


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40