FROSTED SNOWDROP EARRINGS | BEGINNER


5: RINSE & DRY Remove the discs from the pickle, rinse with water and


dry them off.


7: SOLDER Take the larger two discs and place upside down on


5


your soldering sheet. Using spring tongs and third hand, place the ear pin one third of the way from the un-drilled edge of the disc and solder on using hard solder. Once the solder has flowed, put the earrings in the pickle to clean.


7


6: DOME YOUR DISC Place your disc in a shallow section of your doming


block and use a dapping punch and mallet to dome your discs.


8: FROST Remove any fire stain from each component using


6


Garryflex or abrasive papers and clean up around the solder join, checking that the ear pins are secure. Secure the frosting wheel into your motor and frost the back and front of each disc, going in different directions to create a sparkly effect.


HEALTH & SAFETY Always wear safety goggles when using a


frosting wheel.


8


32


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40