PERSONALISED PIERCED SILVER NECKLACE | INTERMEDIATE


12: START TO FINISH Use the benchpeg as support while you are filing; it will


help secure your work. When you are polishing always wear goggles, an apron and dust mask to protect yourself. Before finishing the metal, make sure that all of the scratches have been removed from the surface by using the rough to fine emery paper grades. Always clean your metal before and between the grades and make sure not to move through the different grades too fast otherwise deeper scratches will remain.


12


14: PREPARE THE CHAIN Cut the chain in to two pieces of 7” each.


Use the 4mm heavyweight jump rings to connect the pendant to the chain and to a trigger clasp.


14


15: ATTACH THE CHAIN Using the chain pliers, open up the 4mm jump rings


and join all of the pieces together through the jump rings. Then, use the 5mm jump ring for the end of the chain and you’re finished.


15


13: POLISH Using the Micromesh set, hand polish your piece to


a mirror finish. After filing and sanding the surface of the metal, you can obtain the high polish, satin or different finish desired depending on which accessories you use.


13


24


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40