SPARKLY RESIN PENDANT & EARRINGS | BEGINNER
1: LAY OUT THE PIECES Place the perspex block from the resin kit onto a
piece of card. Lay the pendant flat and place the earring blanks into the holes to keep them flat during the resin process.
1 5
5: FILL IN THE BLANKS Use the mixing stick to pour a few drops of resin into
each earring blank. If necessary, use the mixing stick to carefully push the resin up to the edges of the blank. Continue adding drops of resin until a slight dome forms. Do the same to the pendant blank, then leave to set for at least 24hrs.
2: PROTECT YOUR SKIN Apply the Badger Balm or put on the latex gloves to
protect your hands.
3: MIX THE RESIN Using the scales, weigh your resin (1g is plenty for this
project) with 5% of this weight being the pink paste. Weigh your resin into a mixing pot at a ratio of two parts resin to one part hardener. (1g of resin with paste added and 0.5g of hardener).
3
6: FINISH Attach a Silver jump ring to the loop on the pendant
using a pair of flat pliers, then feed the chain through. Add your scrolls to the back of the studs and you’re complete.
6
4: ADD GLITTER Add a little glitter, stir slowly and well but not
vigorously, with a wooden stirrer. 4
5
SPARKLY RESIN PENDANT & EARRINGS
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40