PERSONALISED PIERCED SILVER NECKLACE | INTERMEDIATE


1: SKETCH Sketch your design on your notepad.


1 4


4: MEASURE & MARK Use the engineer square and scriber to mark out eight


strips measuring 5mm each. Scribe on the other side two sections of 6mm each.


2: MEASURE & SCRIBE Ensure your sheet is 12x40mm. Then, using your ruler,


mark the sheet with a scriber or divider. Avoid making marks too deep. You will need to scribe these lines very lightly as they are only guides.


2


5: MARK A DIAGONAL LINE Mark out a diagonal line where you will write the word


or the name for your pendant. 5


3: FIND THE ANGLE Use the engineer square to find the fair angle of the


sheet. 3


6: MARK YOUR DESIGN Freehand, mark out your design from the second to


the seventh strip and mark two circles on the first and eighth strip.


6


22


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40