RESIN SPHERE DROP EARRINGS | INTERMEDIATE


4: FINISH OFF THE RESIN


SPHERE Drill a hole in the top of the resin spheres (the side the pouring hole was on the mould). Clean up any sharp or rough edges using the finer abrasive boards such as green, orange and white. Mix the epoxy glue according to the manufacturer’s instructions. Dab a small amount of the glue onto the pin of the cup and push into the drilled hole in the resin. Leave to set.


4


5


5: ATTACH THE CHAIN &


EARRINGS Cut the chain to your desired length using side cutters. I used 1.4mm sterling Silver loose oval belcher chain but any other chain of your choice will work, just make sure the jump rings fit through the links of the chain. I used 50mm of chain for each earring.


Open a jump ring using pliers. Carefully put one end of the chain and the loop from one of the earrings on to the open jump ring. Close the jump ring making sure there is no gap. Open another jump ring and put the other end of the chain and the loop from the bead cap onto the jump ring. Close the jump ring.


6: FINISH Attach the scrolls and your project is complete,


I used Silver silicone slider mushrooms.


17


RESIN SPHERE DROP EARRINGS


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40