RESIN SPHERE DROP EARRINGS | INTERMEDIATE


HEALTH AND SAFETY To protect your skin and eyes we recommend


wearing gloves and safety glasses while using the liquid resin.


1: MIX THE RESIN Weigh out the 2g resin, tare the scale and then add 1g


of the hardener. Mix slowly using a mixing stick until the resin and hardener are thoroughly mixed.


1


2


3: POUR THE RESIN INTO


THE MOULD Gently pour the resin mixture into the mould. Again, tap the mould against the table to get rid of the air bubbles. Leave to set for 24 hours (it may take slightly longer if the room is cold). Once the resin is set, remove the sphere from the mould. If you are finding this difficult, do this while running it under warm water to make the mould more flexible. Repeat steps 1 to 3 so you have two resin spheres.


2: ADD THE MICA POWDER Add a small amount of the mica powder (I used


Aquamarine). Swirl it into the mixture, but do not completely mix it in. Tap the mixing pot against the table to bring any air bubbles to the surface.


2 3


16


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40