E-flite Extra 300SC BP


Jim measured and marked the centerline (above left) of the wing and the stab to help in initial alignment with the fuselage. Removing the film about 1 inside the fuselage side made for a clean glue joint between the wing and the


⁄16 inch


fuselage (above right). Opening the hinge slots (below left) with a hobby knife made installing the CA hinges easier. Jim chose to use a tap (below right) to cut the threads in the wheel pant bushings.


Jim used his machinist vise to hold the motor (above left) when attaching the stick type motor mount to the motor. The motor with its plastic motor mount


48


(above left) slides onto the motor stick and is held in place with small screws on both sides of the motor stick.


JUNE 2014


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68