CARGO LIGHTS IGNITED CARGO ONBOARD BULKER: CASE STUDY
In a recently published casebook featuring four case studies, The Swedish Club has shared information about an incident where floodlights caused a cargo fire on a bulk carrier.
Two days into the voyage the crew noticed smoke coming from cargo hold 2. Hot spots were discovered in hold 2 on the transverse hatch coaming, both forward and aft on the portside, and an additional hot spot was also discovered on hold 3 on the transverse hatch coaming, on the portside
aft.All hot spots were located adjacent to recesses in the coamings for the cargo holds’ floodlights. The crew isolated the electrical power to the floodlights. Because of the increased temperature of the hot spots in hold 2, the Master released CO2 into the hold.
The CO2 did not extinguish the fire but reduced its severity for a while. When the vessel arrived at the discharge port the cargo hatches were opened, and flames broke out from hold 2. At the same time a plume of smoke escaped from hold 3. The top layer of cargo in hold 2 had been burned.
Lessons learned – The subsequent investigation revealed that the cargo floodlights were not connected according to the approved ‘as built’ circuit diagrams delivered with the vessel. It was not clear on board which lights were controlled by which keyswitch.
– The fire was caused because a number of cargo lights were operating while cargo covered them, so the lights ignited the cargo. There was a lack of information on board about how the light circuits were connected and how the light system should be operated. There was also a lack of records concerning use of the lights.
– Many bulk carrier/general cargo holds have fixed cargo lights. Halogen-type lights can easily ignite combustible cargoes such as grain, animal feed, wood chips, pulp and paper if they are too close to the light.
– Cargo lights in holds need to be properly isolated before cargo is loaded. This is best done by removing fuses or other physical links in the electrical circuits so that the lights cannot be switched on by mistake. In container ships the lights need to be properly placed so that they do not overheat cargo or other combustibles and thus cause damage or fire. Lights in car carriers and ferries are usually fluorescent, which are unlikely to cause ignition. Nonetheless it makes sense to leave lights switched off when they are not needed, particularly in cargo areas where combustibles are present.
WARNING: CRANE COMPONENTS MUST COMPLY WITH MANUFACTURER RECOMMENDATIONS
The Bureau of Safety and Environmental Enforcement (BSEE) has published details of a potentially serious near-miss recently which occurred on a Gulf of Mexico energy facility. While using the platform crane to suspend a wireline lubricator, the pin holding the hook on the crane stinger backed out, resulting in the hook and lubricator falling.
The incident investigation found that the cotter pin at the end of the hook pin had sheared, which allowed the washer to fall and the pin to back out. Following the backing out of the pin, it caused the ear on the connection to distort, resulting in the hook failing.
The BSEE investigation found there was an inadequate pin configuration design. The pin installed on the hook assembly had a smooth composition. The operator determined that a threaded bolt with nuts and keepers was the proper pin design for ensuring the stinger remains secure throughout lifting operations. Following this event, the operator inspected their other facilities and found the same improper arrangement on additional cranes.
Lessons learned – Be sure to inspect all cranes on the facility and verify that the hook assembly has a threaded pin with nuts and keepers.
– Retro-fit any stingers equipped with an improper stinger hook pin configuration.
– Verify all crane components are in alignment with current manufacturer recommendations.
– Add assessment of the pin condition into the pre-use inspection checklist, which should be completed before conducting lifting operations.
Safety Briefings, The Report, March 2023, Edition 103
9
IIMS 2023 Safety & Loss Prevention Briefings Compendium
Safety Briefings
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116 |
Page 117 |
Page 118 |
Page 119 |
Page 120 |
Page 121 |
Page 122 |
Page 123 |
Page 124 |
Page 125 |
Page 126 |
Page 127 |
Page 128 |
Page 129 |
Page 130 |
Page 131 |
Page 132 |
Page 133 |
Page 134 |
Page 135 |
Page 136 |
Page 137 |
Page 138 |
Page 139 |
Page 140 |
Page 141 |
Page 142 |
Page 143 |
Page 144 |
Page 145 |
Page 146 |
Page 147 |
Page 148 |
Page 149 |
Page 150 |
Page 151 |
Page 152 |
Page 153 |
Page 154 |
Page 155 |
Page 156 |
Page 157 |
Page 158 |
Page 159 |
Page 160 |
Page 161 |
Page 162 |
Page 163 |
Page 164 |
Page 165 |
Page 166 |
Page 167 |
Page 168 |
Page 169 |
Page 170 |
Page 171 |
Page 172