search.noResults

search.searching

saml.title
dataCollection.invalidEmail
note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
Safety Briefings


POOR WIRING RESULTS IN SHIP’S DETENTION


The American Club has shared a case where a ship was detained due to an ISM deficiency, arising from poor wiring.


As there was no electrician onboard, the vessel’s third engineer was sent to investigate why the vessel’s forward anchor light was out. He found the wiring in extremely poor condition. The insulation was missing in some areas and heavily cracked in others. The wire itself was shorted out against the side of the deck penetration. He made repairs using some wire he had in his tool belt and a lot of electrical tape. He then reported that the problem was fixed.


Photo credit: The American Club Two days later, with the vessel still at anchor, a


Port State Control inspector observed the poor wiring and detained the vessel for an ISM deficiency. In the course of investigating the cause of the detention, the Chief Engineer and Master were upset that the third engineer’s repair had been so poor. However, they were more upset that the third engineer had not recognized or reported the need for more permanent repairs consistent with the vessel’s safety management system.


The physical damage to the vessel was minimal. However, the vessel was detained until the wiring was correctly repaired and an external ISM audit was conducted. The wiring was properly repaired for less than $250.


A poor repair could have caused the forward anchor light to fail again. That would have increased the risk of a collision and increased the potential confusion for other vessels manoeuvring into and out of the anchorage. Additionally, the poor electrical repair created an electrical shock hazard.


Photo credit: BSEE


EXTRA CARE REQUIRED WHEN INSPECTING WIRE ROPES FOR EVIDENCE OF WEAR DUE TO FRICTION


The Bureau of Safety and Environmental Enforcement (BSEE) has published details of an incident involving an auxiliary line’s abrading that caused a rope guard to fail and presents the resulting lessons that were learned.


The BSEE investigation found that chronic scraping and rubbing by an auxiliary line created enough damage to the main line idler sheave carrier side plate, pin boos, rope guard, and auxiliary line that it caused the guard of the main load line idler sheave carrier to fail.


The rope guard fell approximately 100 feet, landing near personnel working below. This type of damage occurs when the auxiliary line is used at high speed, thus causing the auxiliary line to jump onto the main line idler sheave.


BSEE confirms that this particular incident involved an American Aero OM 450 crane. Other cranes with a similar configuration could see the same issue and personnel involved with the inspection and maintenance of such equipment are asked to be vigilant.


Key lessons learned - Inspect idler sheaves and wire ropes for wear indicative of friction and abrading when performing pre-use inspections described in API RP 2D.


- Replace single main load line idler sheave carriers with a double sheave idler.


Safety Briefings, The Report, March 2023, Edition 103


18


IIMS 2023 Safety & Loss Prevention Briefings Compendium


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74  |  Page 75  |  Page 76  |  Page 77  |  Page 78  |  Page 79  |  Page 80  |  Page 81  |  Page 82  |  Page 83  |  Page 84  |  Page 85  |  Page 86  |  Page 87  |  Page 88  |  Page 89  |  Page 90  |  Page 91  |  Page 92  |  Page 93  |  Page 94  |  Page 95  |  Page 96  |  Page 97  |  Page 98  |  Page 99  |  Page 100  |  Page 101  |  Page 102  |  Page 103  |  Page 104  |  Page 105  |  Page 106  |  Page 107  |  Page 108  |  Page 109  |  Page 110  |  Page 111  |  Page 112  |  Page 113  |  Page 114  |  Page 115  |  Page 116  |  Page 117  |  Page 118  |  Page 119  |  Page 120  |  Page 121  |  Page 122  |  Page 123  |  Page 124  |  Page 125  |  Page 126  |  Page 127  |  Page 128  |  Page 129  |  Page 130  |  Page 131  |  Page 132  |  Page 133  |  Page 134  |  Page 135  |  Page 136  |  Page 137  |  Page 138  |  Page 139  |  Page 140  |  Page 141  |  Page 142  |  Page 143  |  Page 144  |  Page 145  |  Page 146  |  Page 147  |  Page 148  |  Page 149  |  Page 150  |  Page 151  |  Page 152  |  Page 153  |  Page 154  |  Page 155  |  Page 156  |  Page 157  |  Page 158  |  Page 159  |  Page 160  |  Page 161  |  Page 162  |  Page 163  |  Page 164  |  Page 165  |  Page 166  |  Page 167  |  Page 168  |  Page 169  |  Page 170  |  Page 171  |  Page 172