Lube-Tech
Mehdi Fathi-Najafi and Jinxia Li, Nynas AB, Sweden Yijun Shi, Luleå University of Technology, Sweden
Abstract
Mineral oils that are used by grease manufacturers can be divided into two major groups, paraffinic oils (API Groups I, II and III) and naphthenic oils (API Group V). These categories of base oils have their own advantages and disadvantages depending on the type of applications and cost.
Right now, grease manufacturers are witnessing two major challenges: 1) a shortage of bright stock because of the ongoing rationalisation of paraffinic Group I refineries, and 2) a rapid price increase for lithium hydroxide due to market demands for lithium batteries. These challenges are pushing the grease industry to intensify their development activities in order to be able to provide new products to the market without compromising performance.
The purpose of this paper is to target these challenges, namely, by using naphthenic oils. Traditionally speaking, high viscosity naphthenic oils are only used as a minor part of the formulation of lubricating greases. However, this paper investigates the impact of using two straight cut naphthenic oils, with viscosities of 380 mm2 various thickener types.
/s and 620 mm2 /s, with 32 LUBE MAGAZINE NO.154 DECEMBER 2019
PUBLISHED BY LUBE: THE EUROPEAN LUBRICANTS INDUSTRY MAGAZINE
No.125 page 1
Evaluation of the impact of High Viscosity Naphthenic Oils in various thickener systems
The chosen thickeners were conventional lithium, lithium complex and organophilic clay, which together represent more than 75 percent of the thickener in global grease production.
The greases were fully characterised, including rheological measurements, and thereafter compared with each other. In addition, since high film thickness and load carrying capacity are important parameters for industrial applications, the greases were studied tribologically.
In summary, based on the results obtained, two different but pragmatic solutions were suggested targeting the issues described above. Moreover, the use of wax free naphthenic oils in these formulations resulted in greases with good low temperature mobility, despite the high viscosity of the base oils, and they can be suitable for a number of applications, e.g., in central lubrication systems
Introduction
The base oil industry has been going through fundamental changes in the last decade. These changes have been marked by the rapid growth in production capacity of Group II and Group III base oils.
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68
