Autorotation Fly-Through A Potentially Dangerous Compromise

By Randy Rowles

An increasing number of helicopter flight schools have reduced emphasis on the flare portion of the autorotation due to overspeeding. I’m told the risks of an overspeed outweigh the benefit the student experiences by conducting a positive flare in the early stages of autorotation training. It seems consensus among helicopter flight school leadership is that a gentle reduction in forward velocity to an approximate 30-knot ground speed is enough, and a go-around from this point in the maneuver is the safest solution. To be very clear, this is a dangerous compromise!

The flare portion of the autorotative profile is a key component to the survival of this maneuver. The understanding and ability of the pilot to position the helicopter correctly so that a safe landing can be accomplished is the goal. Leaving a large amount of energy available in the airspeed of the helicopter is a critical mistake. The assumption that every autorotation will end with a long, hard, smooth surface is more fantasy than fact.

The profile of the glide dictates the aggressiveness of the flare in many cases. A high-speed, low-rotor RPM extended glide autorotative profile will begin with a small amount of aft cyclic to engage a deceleration without an altitude increase. However, the airspeed will begin to reduce

rapidly. When this occurs, an increase in the flare profile will allow the helicopter to maintain a low constant altitude above the ground while sustaining rotor rpm. We see this profile often flown at airports with long, low flares to the predetermined point of touchdown. This may not be the suggested profile in an actual emergency autorotation, as the low altitude of the flare is well within the expected obstacle height that includes wires, trees, etc.

A smaller open area two or three times the main rotor diameter of the helicopter is likely a realistic emergency landing area. In these cases, a slower (minimum rate of descent) type autorotation may be better suited. The desired rotor RPM may vary based on the phase of the maneuver. Lower rotor RPM during the glide will provide a slower rate of descent. However, increasing rotor RPM toward the end of the autorotation may aid the flare due to the lower airspeed, which may affect positive energy transfer. In either case, the rotor RPM at the end of the flare will directly affect aircraft controllability and ground run.

I reference airspeed, but ground speed is more important when the skids touch the surface. Airspeed is key for a helicopter to have a functional flare. Once the flare begins and the transfer from horizontal flight to ground contact occurs, the importance shifts to ground speed. A high ground speed when confronted with a marshy area, a busy city street, or a small landing area will most likely be disastrous.

Randy Rowles has been an FAA pilot examiner for 20 years for all helicopter certificates and ratings. He holds an FAA Gold Seal Flight Instructor Certificate, NAFI Master Flight Instructor designation, and was the 2013 recipient of the HAI Flight Instructor of the Year Award. Rowles is currently the owner of the Helicopter Institute. He can be reached at

Training autorotations to fly through the flare portion of the maneuver should be a technique utilized when the maneuver is in jeopardy, or when a go-around is the safest course of action. Using this technique to increase the number of autorotations during a single training evolution is common among helicopter flight instructors, and it may create a potentially hazardous motor skill for the student.

The intent of the performance-based autorotation on the practical test is to measure the applicant’s ability to maneuver the helicopter to within a specified distance from a predetermined spot. Flying through the autorotational flare in training may cause the applicant to be found unsatisfactory during the practical exam...and a compromised flare during an actual emergency autorotation may find you sharing space with the same obstacle you tried to avoid!

If you have any comments or questions, please let me know at

86 July/Aug 2019

Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74  |  Page 75  |  Page 76  |  Page 77  |  Page 78  |  Page 79  |  Page 80  |  Page 81  |  Page 82  |  Page 83  |  Page 84  |  Page 85  |  Page 86  |  Page 87  |  Page 88  |  Page 89  |  Page 90