BS EN ISO 6185-3:2018 ISO 6185‑3:2014


Annex A (informative) General arrangement of a typical Type VII boat


Figure A.1 depicts a single outboard powered inflatable boat that is controlled by remote steering and engine controls mounted on an offset installed control console grip throttle control. This illustration should only be used as a guide for the reader to identify the components that typically make up a type VII boat.


Key 1 motor 2 transom


3 lifting/carrying device 4 fuel tank


5 buoyancy tube comprising several buoyancy chambers or compartments 6 safety rope or lifeline 7 inflation valve 8 towing device


9 spray cover 10 remote steering


11 partition bulkhead — example of a transverse partition 12 grab handle


13 inboard area 14 paddle or oar 15 battery


16 builder’s plate Figure A.1— Arrangement of a Type VII boat


© ISO 2014 – All rights reserved


27


Distributed through RYA Online Standards Access under Licence No: 2020ET0001 © BSI


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43