BS EN ISO 6185-3:2018 ISO 6185‑3:2014
8.7 Self‑Draining (type VIII Boats only)
8.7.1 Requirements The Type VIII boat shall be capable of self-draining within 5 min when tested as in 8.7.3 or when assessed by calculation as in 8.7.4.
8.7.2 Self‑draining test requirement
Closely examine the boat at the end of the test described in 8.7.3. The cockpit areas shall self-drain down to a level of 100 mm above the waterline or 100 mm depth of residual water, whichever is lower.
8.7.3 Test method
Ensure that there is no water within the boat. Prepare the boat to the fully loaded capacity (mLDC). The distribution of this load shall represent the boat fitted with motor(s) of the maximum power rating and passengers seated in their normal positions. Close any cockpit drains and scuppers while filling. Fill the cockpit areas with water until it starts to flow out overboard. Open the cockpit drains and scuppers and check that the cockpit drains in less than 5 min by gravity or forward motion of the boat but without using any manual or electric bilge pump or draining device.
8.7.4 Self‑draining calculation requirement Calculate the draining time according to ISO 11812.
9 Builder’s plate(s)
The boat shall be equipped with printed or engraved plates in accordance with ISO 14945. Additional data may be supplied as long as it does not contradict ISO 14945.
The craft identification number shall be shown in accordance with ISO 10087 and be mounted separately to the builder's plate.
Where the builder wishes to assign more than one design category to a boat, the display shall be such that the crew limit and the maximum load are clearly identified to belong to a specific design category. NOTE
10 Owner's manual
An Owner's Manual shall be supplied in (a) suitable language for the intended market(s) and in simple terms, sufficient to enable the operator to correctly assemble, inflate and prepare the boat for use afloat including reference to lifting devices, the location/fixing of seating, steering system, battery and fuel tank (where applicable).
Guidance shall also be given in the Owner's manual on: — drying, storage and servicing of the boat; — positions of the seating and handholds for the crew for each of the Design Category condition.
A warning notice shall be given in the Owner's manual concerning the final assembly of the boat prior to the delivery. For example: © ISO 2014 – All rights reserved
25
Notwithstanding that ISO 14945 excludes inflatable boats, the requirement for the uniform display of
information to be exhibited on the builders plate as determined by that standard is entirely applicable to Type VII and Type VIII boats.
Distributed through RYA Online Standards Access under Licence No: 2020ET0001 © BSI
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43
