BS EN ISO 6185-3:2018 ISO 6185‑3:2014
6.16 Fire protection (if applicable) Boats shall comply with ISO 9094. 6.17 Openings in hull, deck or superstructure
Windows, portlights, doors, hatch covers and other openings in the hull, cockpit and superstructures whose defect could lead to flooding the interior of the boat shall comply with ISO 12216. Seacocks and thru hull fittings shall comply with ISO 9093.
6.18 Gas systems Liquefied petroleum gas (LPG) systems for domestic use, where fitted, shall comply with ISO 10239. 6.19 Navigational lights
Navigation lights, where fitted, shall comply with international regulations and/or national regulations where applicable. NOTE
Guidance can also be found in ISO 16180.[2] 6.20 Discharge prevention
Boats shall be constructed so as to prevent the accidental discharge of pollutants (oil, fuel) overboard. Boats fitted with permanently installed toilets shall be fitted with holding tanks or provision to fit holding tanks which shall comply with ISO 8099.
Any through hull piping for toilet discharge shall be fitted with seacocks complying with ISO 9093 and that can be secured in the closed position.
7 Safety requirements of the completed boat
7.1 Maximum Load Capacity The maximum load capacity shall be determined according to ISO 14946 except that, stability and buoyancy tests or calculations shall be conducted according to 7.3 and 7.4 respectively.
7.2 Crew limit (CL)
The CL as defined in 3.11 shall not exceed the number of persons for which seating or seating spaces have been assigned or the limitations imposed by 7.3, 7.4, and 7.5.
For design categories C and D, the number of seating spaces may include the interior floor and buoyancy tubes, when these are used as seating areas, as well as fixed seats. Seats and seating areas shall meet the size requirements of ISO 14946.
For design category B, the number of seating spaces shall be limited to the number of fixed seats conforming to 6.10.
7.3 Static stability
7.3.1 Except as described in 7.3.2 for boats which are fully enclosed, the static stability shall comply with the sub-clauses of ISO 12217-1:2013 as specified in Table 3
© ISO 2014 – All rights reserved
13
Distributed through RYA Online Standards Access under Licence No: 2020ET0001 © BSI
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43
