BS EN ISO 6185-3:2018 ISO 6185‑3:2014
6.6 Transom (where applicable)
6.6.1 Requirement The transom or motor mount and its attachment to the boat shall be designed to withstand, under normal use, the maximum stresses arising from:
— the output power and torque of the motor(s); and — the mass of such motor(s). NOTE
6.7 Hull drainage
If the boat is fitted with a transom, it shall be equipped with at least one drainplug or one bailing system. For boats fitted with an integral closed hull/cockpit assembly which is not filled with closed-cell foam or equivalent, a facility shall be provided for draining the interior part of the hull (bilge).
Means to prevent the accidental discharge of oily waste shall be provided. 6.8 Remote steering system (where offered as standard or optional equipment)
Any remote steering system shall conform to at least one of the following standards: ISO8847, ISO8848, ISO 9775, ISO 10592 and ISO 15652.
For boats fitted with a single inboard engine and remote steering systems, a manual means of emergency steering at reduced speed shall be provided (for example, an oar, a paddle or other means) Type VIII boats shall be fitted with a remote steering system approved by the boat manufacturer.
If remote steering and control consoles are fitted, these structures shall meet the strength requirements of 7.13. 6.9 Towing, anchoring and mooring devices All boats shall have towing, anchoring and mooring devices in accordance with ISO 15084.
6.10 Seating and attachment systems (where offered as a standard or optional equipment)
Seat is any surface, horizontal or nearly horizontal, where a person may sit. Where a seat structure (s) is supplied and permanently fitted to the boat by means of an attachment system, the seat and the attachment system shall meet the strength requirements of subclause 7.13.
Type VIII boats shall have a seat structure and attachment system for each person up to the crew limit (CL) for operation in Design Categories B. Buoyancy tubes shall not be used for seating areas except when operating in Design Categories C and D.
Seating and handholds for Type VIII boats shall provide support for the upright posture for each person up to the crew limit (CL) and be designed to prevent them from falling or being thrown on deck.
Un-cushioned locker tops or benches shall not be accepted as seats for operation in Design Category B. NOTE With respect to falling overboard, see 7.9.
ISO 12215-6 gives recommendations on transoms of outboard engines.
© ISO 2014 – All rights reserved
11
Distributed through RYA Online Standards Access under Licence No: 2020ET0001 © BSI
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43
