BS EN ISO 6185-3:2018 ISO 6185‑3:2014


Dimensions in metres


Key 1


2


test mass test mass pulled within 1m of the test accessory


3 2m retainer wire [free hanging (3a) and under tension (3b)] 4


test accessory (steering console is depicted) Figure 3— Testing the strength of factory fitted accessories


7.13.4 Test method B


Any cordage used for test purposes shall have a diameter of 8mm. Prepare the accessory to be tested by fitting it in the boat or a sample piece of the cockpit using exactly the same method as the production series.


Gradually load the accessory up to 2000 N in the upward and downward vertical directions, the horizontal fore and aft directions as well as the transversal port and starboard directions, maintaining this load for 60 s each time.


20


© ISO 2014 – All rights reserved


Distributed through RYA Online Standards Access under Licence No: 2020ET0001 © BSI


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43