BS EN ISO 6185-3:2018 ISO 6185‑3:2014
There shall be no structural failures in the form of fractures, cracks, tears, separation, etc. on any part of the hull or boat component, such as the cockpit or thwarts, and including any boundary interface such as floor/hull, cockpit/transom, buoyancy tube/hull, etc.
8.2.2 Test method
Prepare the boat to the fully loaded condition (mLDC). The distribution of this load shall represent the boat fitted with motor(s) of the maximum power rating and the crew (CL) seated in their normal positions.
Consecutively drop the loaded boat from a height of 2 m (from water to lowest point of boat) into the water using three different boat attitudes:
a) horizontal; b) bow down 45°; c) stern down 45°.
8.3 In‑water performance
8.3.1 Requirement The boat shall be equipped with any load-bearing accessories offered as standard or optional equipment. Test the boat, in the manner described in 8.3.2, fitted with motor(s) of the maximum power rating. Closely examine the boat at the end of the test period. There shall be no:
a) structural failures in the form of fractures, cracks, tears, separation, etc. on any part of the hull and floor or and including any boundary interface such as floor/hull, cockpit/transom, buoyancy tube/hull, etc.;
b) structural failures in the form of fractures, cracks, tears, separation, etc. on any boat component, such as the cockpit or thwarts;
c) damage to any accessory or to the method of attachment to the boat; d) signs of abrasion that could result in subsequent structural damage or failure; e) tendency of the boat to overturn; f) evidence of the boat not remaining reasonably dry; g) hindrance to the coxswain maintaining reasonable visibility at all times.
8.3.2 Test methods
8.3.2.1 General Use the remote steering system if it is supplied as standard equipment. If it is offered as optional equipment, carry out the test using both tiller and remote steering systems consecutively.
Use the coxswain and crew-member seating systems if they are supplied as standard or optional equipment.
22
© ISO 2014 – All rights reserved
Distributed through RYA Online Standards Access under Licence No: 2020ET0001 © BSI
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43
