The wing is built on a flat surface except for the tip which has washout built in. Remember to be careful as there are both left and right assemblies.


The wing is built in two sections. This section (above left) is the inside section showing the landing gear frame with lead shot bags being used to hold the assembly as it dries. Outer section of the wing (above right). Note the two cardboard tubes used to run leads for the outer aileron and flap. One of the


several hatch covers (below left) with a pushrod used to actuate the aileron. Although not shown remember to use clevis keepers to prevent the linkage from opening. Before gluing the stabilizer in place (below right), check that the stabilizer is both square to the fuselage and parallel to the wing saddle.


FLYING MODELS


49


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68