11-08 :: August 2011
nanotimes News in Brief
Ronald Holzwarth from Menlo Systems Ltd. and pro- mises to radically reduce the size of frequency comb generators.
Using a “nanowire” made of glass the scientists couple light from a diode laser into this monolithic structure, where it is stored for a rather long time. This leads to extremely high light intensities inside the resonator, i.e. photon densities, which again produce nonlinear effects such as ‘four-wave mixing’ induced by the Kerr effect: two light quanta of equal energy are converted to two photons of which one light quantum has a higher energy, the other a lower energy than the original ones. The newly produced light fields can in turn interact with the original light fields, thereby producing new frequencies. From this cascade emerges a broad, discrete spectrum of fre- quencies. By optimizing the geometry of the toroid microresonator, Dr. Pascal Del’Haye (MPQ) and Tobias Herr (EPFL), doctoral students at the refer- red experiment, have managed to compensate the effects of dispersion, such that the photon round-trip time inside the resonator remains the same for all light frequencies. Now the microresonators produce light over the range of more than an octave, from von 900 bis 2170nm (near IR), for the first time. (As on the keyboard of a piano, the range of an octave corresponds to a doubling of the frequency.)
By raising the intensity of the light coupled into the resonator the frequencies of the comb can be shifted simultaneously. The higher intensities increase the temperature of the glass structure by up to 800° Cel- sius (1,472° F) whereby the resonator is expanding and changing its index of refraction. Both effects lead to a shift of the comb lines towards lower frequen- cies, i.e. longer wavelengths. The broad range of
57
frequencies as well as the tunability is an important pre-condition for self-referencing, where the lower range of the spectrum is doubled and compared to the upper part. Self-referencing is an important pre- condition for the use of frequency combs in metro- logy.
Also optical telecommunications will profit from the new tool. Whereas in the conventional frequency comb the lines are extremely close and of very low intensity, the spectral lines of the monolithic fre- quency comb have a separation of about 850 giga- hertz and powers of the order of one milliwatt. This spacing and power level corresponds to the typical requirements for the “carriers” of the data channels in fibre-based optical communications. Tunability and broad range make the device also suitable for very precise calibration of spectrographs for astro- physics. Due to the large variety of possible applica- tions many groups worldwide show interest in using the resonators for the miniaturization of photonic devices. A number of other geometries and materials are investigated, e.g. polished crystals, highly re- flective fiber cavities and silicon structures based on computer-chip technology.
P. Del’Haye, T. Herr, E. Gavartin, M.L. Gorodetsky, R. Holzwarth and T. J. Kippenberg: Octave Spanning Tuna- ble Frequency Comb from a Microresonator, In: Physical Review Letters, Vol. 107(2011), Issue 06, August 05, 2011, Article 063901 [4 pages], DOI:10.1103/PhysRev- Lett.107.063901:
http://dx.doi.org/10.1103/PhysRevLett.107.063901 http://www.mpq.mpg.de/
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103