Automated schematic creation using Designer and Project Builder


EPLAN Cogineer is structured into two working areas: the Designer and the Project Builder. The Designer uses EPLAN macros to generate rule sets. The rule sets are then used by the Project Builder to automatically generate full as well as partial schematics.


Designer


Project Builder


A special feature that makes using EPLAN Cogineer very easy and intuitive is that the views and selection options amend themselves automatically in line with the configurations stored within the Designer. The Project Builder interface is therefore always fully consistent with the rule set defined within the Desig- ner – no manual access or programming is necessary.


A major strength of EPLAN Cogineer is its intuitive usability and deep scope combined with a high level of achievable automated schematic creation. All data is fully integrated into the EPLAN Platform.


Design Methods The design method "automated schematic creation" means EPLAN Cogineer speeds up the engineering process while helping to avoid the errors that can occur in conventional copying and pasting.


Design Methods


3


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72