search.noResults

search.searching

dataCollection.invalidEmail
note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
NG IT OVER nd gives expert advice on how to get the best results on every job.


Follow the manufacturer’s instructions when mixing the product, especially the water to powder ratio as this affects consistency, drying times and product performance. Always mix at a slow speed, until a lump-free consistency is achieved.


Once the required consistency is achieved, pour the mix over the prepared substrate and spread to the required depth using a suitable steel finishing trowel or long handled blade. Work the mixture well into the corners, edges and around projections. When you’ve finished spreading the mixture


twitter.com/TContractFloors


on the floor, pour some more mixture onto the floor and spread that out and blend it in with the previous area.


Before allowing to cure, ensure that the surface is sufficiently smooth to receive floorcoverings without any further treatment. If any trowel marks remain, rub down before the compound has hardened (after three hours).


When levelling outdoors, consider the use of a two-part latex or acrylic product such as BAL Acrybase. Remember to check the products you’re using with the manufacturer to ensure stability for use.


Always allow the new floor to set before laying your finished floor surface. Setting times can vary depending on your chosen product and upon your floor finish. For example, an 80mm layer of BAL Level Max can be tiled after just 4 hours at 20°C and a minimum of 24 hours for other suitable soft flooring finishes.


Finally, we would always advise checking suitability with the product manufacturer to ensure compatibility for its intended purpose prior to application to ensure project success.


www.bal-adhesives.com LEVELLING COMPOUNDS | 33


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58