This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
AM100 models are for hydronic heating applications. Straight thru design (hot & cold at same level). Lockable handwheel. Nickel plated brass/bronze construction.
AMX100 models are for domestic water applications. Designed to be installed directly on the water heater "Hot" discharge port. Integral check valve on cold water port. Bronze/stainless steel construction. Certified under ASSE1017, CSA & IAPMO approved.
AM100C models are for use with PEX systems for radiant heating. Straight thru design (hot & cold at same level). Lockable handwheel. Nickel plated brass/bronze construction.
MIXING VALVES - LEAD FREE CAT. NO. MFG. NO.
2K605LF AM100-US-1LF 1/2" Sweat - half Union 2K606LF AM101-US-1LF 3/4" Sweat - half Union 2K596LF AM101-1LF 2K607LF AM102-1LF
3/4" FPT 1" FPT
2K584LF AMX100-US-1LF 1/2" Sweat - half Union 2K585LF AMX101-US-1LF 3/4" Sweat - half Union 2K600LF 12LF70A 2K596LF AM101-1LF
The ARGO DPM2 monitors outside temperatures to adjust boiler water temperatures to match outdoor demand, maximizing efficiency and reducing fuel usage. Typical heating cost savings average 10-15% annually (depending on climate). The DPM2 reduces/increases boiler tempera- tures gradually reducing expansion/contraction noises in the home. Can be used in conjunction with any "ARM" series relay with supplied data port wiring harness, or as a stand alone control. DPM2 controller supplied with "ARM" relay compatibility cable, strap on supply water sensor, and outdoor sensor with shield.
CAT. NO. MFG. NO. POWER SUPPLY RELAY CAPACITY
5C915 DPM-2 20-28 VAC / 2 VA 24 VAC / 48 VA
* Accurate up to 500' with 18 gauge wire 700 Visit us at www.remichel.com // Sensor RESET RATIO MAX. TEMP. DIFFERENTIAL EACH