This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
Designed to remove wheels without damage to shaft or sheet. Hex type handle for wrench ap- plication. Made of rust resistant alloys. T bar on end of handle for maximum leverage.
CAT. NO. DESCRIPTION EACH 4M201
FB-2 Heavy Duty $90.74 THE ULTIMATE PULLER
Blower wheel pusher, fan blade puller and sheave puller. Saves time and money, won’t damage blades or wheels, accommodates 5/8" belt drive and 1/2" or less drive motor shafts. Its’ narrow neck design centers the tool’s pull- ing bolt evenly on the motor shaft.
Features include unique set screws that can be used with both a wrench or hex key and sight holes for aligning puller on motor shaft.
CAT. NO. DESCRIPTION 1X4541
EACH UP-1 Hub/Pulley/Fan Puller $103.84
Single outlet blower with square flange used on heating, ventilating and cooling equipment 3000 RPM, 115 volt. 60 cy. Full load amps 1.02 . Blower wheel 3-13/16 dia. x 1-7/8" wide. Discharge opening 2-1/2" square. Flange size 4 x 5-1/8". Rated at 140 CFM free air, 125 CFM at 0.3"static pressure