[RIGGER’S CORNER]
SYNTHETIC SLINGS vs.
HARSH HOOKS
BY MIKE PARNELL, PRESIDENT, ITI INDUSTRIAL TRAINING INTERNATIONAL,
WWW.ITI.COM
variety of industries use synthetic slings to move equipment and product on a daily basis. Like most other sling types, synthetic web slings and synthetic roundslings serve to help provide acceptable rigging methods for load handling. In the same locations, loads may be rigged using steel slings made from wire rope and alloy chain. Spreader bars and lifting beams get used on certain loads to help avoid sling-to- load contact, and increase sling angles thereby lessening the individual sling tensions.
A
Especially when a mix of rigging equipment is used at one location, the rigger should pay special attention to the crane hooks in use. Multiple lifts (hundreds and thousands) with steel rigging can result in peening, gouging and displacement of the material in the hook bowl or saddle. Tough not exceeding the removal criteria established by the hook manufacturer, this phenomenon can result in sharp edges towards the outer face of the hook. If synthetic slings are placed directly into a peened hook bowl, the edges can act like a razor and sever the sling during the rigging and lifting process. Tis same type of event can occur when rough shackles that are regularly used with steel rigging, are placed into service with synthetic slings.
Always look at the contact point to which synthetic rigging is connected. Sling protection used along the body can prevent friction or cutting damage. However, a peened hook or shackle can cause just as much devastation. Inspect the contact points used with all rigging. If hardware or connection devices can cause damage or severing of a sling while under tension, tag out the component and get it repaired or replaced. Certain hardware manufacturers allow for hand filing and buffing of their components to help maintain smooth surfaces. Follow the manufacturer’s instructions about repair and maximum allowable loss of cross-section criteria when considering hardware repair. y
78
NOVEMBER-DECEMBER 2011
WIRE ROPE EXCHANGE
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80