This page contains a Flash digital edition of a book.
If You Must Winterize...


If you use your boat year-round, you probably have a small heater on board to protect your systems between frequent sails. However, if you leave your boat for any extended period of time, there are steps you should take to insure boat systems’ survival through the winter.


Jack and Alex Wilken We are in denial about summer


being over. Today we needed protective gear to keep the liquid falling from the sky off of us and to deal with the somewhat lower temperature. This, for some of you, will signal putting your boat to bed for the “not summer season.” Maybe if we do not say the “W” word, it won’t happen! But, to bite the bullet, let’s talk about winterizing. Things are going to get cold and wet. There are many concerns, but the first thing to think about is freezing. Depending on your boat’s particular configuration, the idea is to not leave any standing water in any of the systems which could freeze, expand and break something. Raw water system- The freezing


point of seawater is about 28.4°F (-2°C), depending on its salinity, and 32°F (0°C) is the freezing point for ordinary water. Water must be drained from the whole system including the thru hull, the raw water strainer, raw water pumps, any manifolds, valves, engine parts, exhaust water lifts, and mufflers. If you have an outboard motor, flush and drain it. Impeller pumps are usually drained by removing the front plate. (Figure 1) The water can be removed from the strainer by a drain


or by unscrewing and emptying it. Engine exhaust manifolds and water jackets should have a drain. (Figure 2) The system should be left empty, or full of the appropriate antifreeze.


Fresh water system: Empty fresh


water tanks and pump non-toxic antifreeze through the system. Open all showers, faucets and let them run until you have antifreeze coming out. Check any sumps to make sure they are empty. We only know of one bio- friendly glycerin coolant. All the others are glycol based ethylene glycol or propylene glycol. Ethylene glycol is typically used in engines and is highly toxic. Propylene glycol is considerably less toxic but may be labeled “non-toxic antifreeze” and can have a negative environmental impact when you flush out your system in the spring.


Fuel: Gasoline and Diesel are both


treated differently. It is important to know whether


Figure 1: Impeller pumps are usually drained by removing the front plate. 48° NORTH, NOVEMBER 2011 PAGE 28


the gas in your tank has ethanol in it. If the answer is “Yes,” you should consider using or transferring the gas somewhere else. The reason for this is that when water comes in contact with ethanol, as it has a good chance of doing during the winter, it is absorbed until a saturation point is reached. Then, the water, ethanol, and the gasoline will phase separate, forming two or three distinct layers in the tank. This is irreversible. With regular gasoline, the best advice is to use a gasoline stabilizer and keep your tanks 1/4 to 1/2 full so that in spring you can put new fuel in the tank to bring the octane level back up. Buy it at a fuel dock that gets frequent deliveries and always ask if their gas has ethanol in it. For diesel, fill the tank and mix in an additive to kill fungus.


In both cases, gas and diesel, install


a water separator in the fuel line before the main filter. It is recommended that you change your oil now so the acid that forms in used oil does not have a chance to eat at your engine during the long winter nights.


Covers: Varnish and bright work


can take a real beating in the winter so covering handrails and other treated wood can save you work in the spring. In some cases, such as with tillers, you may be able to remove them to protect the wood. This will also give you a chance to varnish them to prepare for your next sailing season. If you have doubts about the condition of the varnish on other parts of the boat, it is probably better to give them a couple of coats when the weather permits. Another thing to consider about


freezing weather is again that pesky standing water. If you have a place on your deck that water can get into in any quantity, it will then expand as it freezes. This is called frost wedging and in nature it can crack and break huge boulders. Avoid having low places in your covers and awnings that will collect water because ice can cut them with its sharp edges.


Mold: To grow, it needs moisture,


humidity of around 50%, a lack of ventilation, and organic matter — for example; dirt, dust, clothes, paper, wood, etc. If you want to make it


Figure 2: Engine exhaust manifolds and water jackets should have a drain.


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74