AM100 models are for hydronic heating applications. Straight thru design (hot & cold at same level). Lockable handwheel. Nickel plated brass/bronze construction.
AMX100 models are for domestic water applications. Designed to be installed directly on the water heater “Hot” discharge port. Integral check valve on cold water port. Bronze/stainless steel construction. Certified under ASSE1017, CSA & IAPMO approved.
AM100C models are for use with PEX systems for radiant heating. Straight thru design (hot & cold at same level). Lockable hand- wheel. Nickel plated brass/bronze construction.
CAT. NO. MFG. NO. MAX FLOW GPM EACH 8G0234 AM100-US-1 8 8G0234A AM101-US-1 12 2K595 2K596
½” Sweat half Union $145.35 ¾” Sweat half Union $176.50 ½” FPT ¾” FPT 1” FPT
¾” Sweat half Union $162.44 1” Sweat half Union $189.61 ½” Sweat half Union $174.65 ¾” Sweat half Union $188.46 1” Sweat half Union $213.52 ½” FPT ¾” FPT
$174.22 $185.37 $248.57
AM-1-020RP Repair Kit for AM-100 Series Valves (C Range 80-125°F)
EACH
4G7466 AM100-002RP Repair Kit for AM 100 Series Valves $48.50 2K590
2K592
AM-1-025RP Repair Kit for AM-100 Series Valves (STD Range 100-145°F)
$62.69 $62.69
$185.20 $193.43
HEATMANAGER™ HYDRONIC HEATING SYSTEM ECONOMIZER
The Beckett HeatManager™ is a patented microprocessor-controlled fuel-saving device for residential hy- dronic heating systems. The HeatManager™ reduces fuel consumption, wear on boiler parts and burner emis- sions by actively managing the burner, in conjunction with the aquastat, to properly match the boiler output to the required load. No requirement to penetrate outside walls; sensor and wiring connections completed at the boiler. Comes complete with sensor for heating only applications. Additional sensor required for heating with tankless coil applications. After installation, no maintenance is required. Dimensions: 4”H x 4”W x 2-1/2”D. 5 year warranty.
CAT. NO. MFG. NO. DESCRIPTION 4H465
4H465A
7512 7518
EACH HeatManager™ Hydronic Economizer $261.41 Sensor for Htg.w/Tankless Coil Applications $45.62
FUEL ECONOMIZER
demand, maximizing efficiency and reducing fuel usage. Typical heating cost savings average 10- 15% annually (depending on climate). The DPM2 reduces/increases boiler temperatures gradually reducing expansion/contraction noises in the home. Can be used in conjunction with any “ARM” se- ries relay with supplied data port wiring harness, or as a stand alone control. DPM2 controller supplied with “ARM” relay compatibility cable, strap on supply water sensor, and outdoor sensor with shield.
CAT. NO. MFG. NO. POWER SUPPLY RELAY CAPACITY Sensor
5C915 DPM-2 20-28 VAC / 2 VA 24 VAC / 48 VA 1005 Ohms at 70° F* 0.5 - 1.5 * Accurate up to 500’ with 18 gauge wire
484
RESET RATIO MAX. TEMP. DIFFERENTIAL EACH 150° - 210° 5° - 15°